Before you call for service...
Troubleshooting Tips
Save time and money/. Review the charts on the following
pages first and you may not need to call for service.
GEAppliances.com
What To Do
Topburners do notlight * Hake sure electricalplug is plugged into a live,properly
or do not burn evenly grounded outlet.
Possible Causes
Plug on range is not completely
inserted in the electrical outlet.
Burner hole or slits on the side
of the burner may be clogged.
• Removethe burners (on models with standard twin
burners)or burner heads and caps (on models with
sealedburners)and clean them with a sewing needle
or twist-tie. Hake sureyou do not enlarge the holes.
On sealedburner models,checkand clean the electrode
area for burned-on food or grease.
Improper burner assembly. • Hake sure the burner parts are installed correctly.
Seethe Coreand cleaningof the range section.
Burner flames very Improper air to gas ratio. • Ifrange isconnected to LPgas, contact the person
large oryellow who installedyour range or made the conversion.
Surface burners light Theoven gas shut-off valve • To check the oven gas shut-off valve on sealed burner
but oven does not may have accidentally been models,remove the warming drawer, storage drawer or
moved during cleaning or kick panel (seethe Care and cleaning of the range section)
moving, and lookfor the gas shut-off leverat the backof the range.
Leveris
shownclosed.
PULLTOOPEN.
Sealedburnermodels
Tocheck the oven gas shut-off valve on standard twin
burner models, raise the cooktop and look for the gas
shut-off leverat the extreme right rear corner. Follow
the directions in box A or B that match your regulator
type.
_jVLeLr_sh_EW_c_
Standardtwin burnermodels Standardtwin burnermodels
Controlsignals after Youforgot to enter a bake
entering cooking time or temperature or cleaning time.
start time Ionsomemodels)
• Touchthe Bake pad and desired temperature
or the SelfCleanpad and desiredclean time.
Clockand timer Plug on range is not completely • Hake sure electrical plug is plugged into a live,
do not work inserted in the electrical outlet, properly grounded outlet.
tonsomemodels)
A fuse in your home may be • Rephce the fuse or reset the circuit breaker.
blown or the circuit breaker
tripped.
Oven controls improperly set. • Seethe Usingthe clock and timer section.
45
m
)
O
r:'
m
O"
ii!iiiiiiliiil
;i:::_ii!iiiii_i!
!:i!:'!!ii::::i!:iii!
)
£
To Next Page
Loading...
