GE HEALTHCARE
DIRECTION 5162630, REVISION 3 LOGIQ™ S6 SERVICE MANUAL
5-16 Section 5-3 - Block Diagrams and Theory
5-3-3 General Information
• LOGIQ™ S6 is a phased and linear array ultrasound imaging scanner. It has provisions for analog
input sources like ECG and phono. A dedicated Doppler probe may also be connected and used.
• The system can be used for:
- 2D Black and White imaging
- 2D Color Flow
- M-Mode Black and White imaging
- Color M-Mode
- Doppler
- a number of combinations of the above
• LOGIQ™ S6 is a digital beam forming system that can handle up to 192 element linear probes
through multiplexing.
• Signal flow from the Probe Connector Panel to the Front End, to the Mid Processors and Back End
Processor and finally to the monitor and peripherals.
• System configuration is stored on a hard disk and all necessary software is loaded from the hard
disk on power up.
To Next Page
Loading...
