GE LOGIQ S6

GE HEALTHCARE
DIRECTION 5162630, REVISION 3 LOGIQ™ S6 SERVICE MANUAL
6-28 Section 6-6 - Jumper and Dip Switch Setting
6-6-3 Mitsubishi MD-3000 VCR Dip Switch Setting
This section describes Mitsubishi MD-3000 VCR communication setting. Field Service Engineer (FSE)
is not allowed to modify dip switch setting. Following setting is documented for purpose of
troubleshooting by FSE.
6-6-3-1 Mitsubishi MD-3000 VCR Dip Switch Setting
6-6-3-2 Accessing Dip Switch Module for inspection
1.) Remove the two screws of RS232C board plate.
Figure 6-108 MD-3000 Dip Switch
Figure 6-109 Opening Board Plate
1 2 3 4 5 6 7 8
ON
OFF
SW5001
1 2 3 4 5 6 7 8
ON
OFF
SW5001
Serial Communicatiton USB Communicatiton
Screws
RS232C board plate