GE HEALTHCARE
DIRECTION 5162630, REVISION 3 LOGIQ™ S6 SERVICE MANUAL
Section 5-5 - Common Service Platform 5-27
5-5-3-2 Service Login (cont’d)
4.) Select GE Service at the “Select User Level” field.
5.) Enter the password for the Service Platform.
6.) Click on Okay.
5-5-3-3 Access / Security
The service interface has different access and security user levels. Users are only granted access to
the tools they are authorized to use.
NOTE: *For a GE Field Engineer, the password changes at specific intervals.
Except for iLinq, all access to the service interface is via the Network port. A modem on the scanner is
specifically intended for iLinq use.
Every access request, whether successful or not, will be logged into a service access log that is
viewable to authorized users.
Figure 5-53 Select User Level
Table 5-46 User Level
User Level Access Authorization
Operator
These service tools are normally used in-house and are protected with a special scanner configuration
that is not allowed to leave the facility.
Administrator
Use the OnLine Center access method provided by iLinq.
External Service
Required for a external Service other than GE FE.
GE Service
Requires a network connection and knowledge of a password.*
To Next Page
Loading...
