GE LOGIQ S6 User Manual

GE HEALTHCARE
DIRECTION 5162630, REVISION 3 LOGIQ™ S6 SERVICE MANUAL
8-10 Section 8-3 - Software Loading Procedures (R7.7.x or later with BEP4)
8-3-5-4 Saving Connectivity
Before starting upgrading, write down
the Connectivity Setting for back-up.
1.) Touch Utility > Connectivity on the touch panel and click the TCP/IP tab.
2.) Write down the following parameters:
Figure 8-117 TCP/IP Screen
Table 8-63 Saving Connectivity
Parameters Descriptions (Entry for Stand-Alone System)
Computer Name
Enable DHCP This parameter must NOT be selected.
IP-Address (192.168.1.2)
Subnet Mask (255.255.255.0)
Default Gateway (192.168.1.1)
Note : For a stand-alone system, preset values of IP adress, subnet mask, and default gateway, shown above,
must entered.
Remove the
Check mark.

GE LOGIQ S6 Specifications

General

Brand	GE
Model	LOGIQ S6
Category	Medical Equipment
Language	English