GE HEALTHCARE
DIRECTION 5162630, REVISION 3 LOGIQ™ S6 SERVICE MANUAL
4-10 Section 4-2 - General Procedure
4-2-5-2 Using Regional Preset
Regional Preset is selected during Application Load (Refer to 8-8-13 - Installing R7.x.x Application
Software for details).
Current Regional Preset is displayed under Utility > System > About .
Factory Default Regional Preset can be re-loaded from Utility > Systme > About > Additional About.
Figure 4-19 Current Regional Preset
NOTICE
For Upgraded BT08, this field always shows "None" as Region Preset is feature available for pure BT08
and onward.
Figure 4-20 Factory Default Regional Preset
To Next Page
Loading...
