GE LOGIQ V3 - Network Configuration

GE LOGIQ V5/LOGIQ V3
D
IRECTION 5496012-100, REVISION 3 BASIC SERVICE MANUAL
7 - 8 Section 7-2 - Gathering Trouble Data
Section 7-5
Network Configuration
7-5-1 Network Configuration
1.) Connect system with network.
2.) Enter Utility-> Connectivity-> TCP/IP, in IP settings window, check Enable DHCP, and select the
proper network speed in Network Speed.
NOTE: If user wants to setup static IP address, uncheck Enable DHCP option, input static address in
IP-Address box, Subnet Mask and Default Gateway box. In Network Speed, choose the
proper speed available.
Figure 7-5 Enable DHCP
Figure 7-6 Input static address