Marquette Hellige GmbH MAC 1100/1200 V 1.1 Page 39
227 492 20 D - 0002
3.15 Pace enhance
Pressing the “P" key calls up the following menu:
P a c e enhance
1= ON
2= OFF
X= End
The currently selected pace display mode appears in reverse video.
ON: Standard pace display mode.
Detected pace pulses are displayed as special defined pulses
OFF: Pace pulses are displayed with there own pulse form directly
The factory setting is ON. This should only be changed when deemed really
necessary.
3.16 Serial number
The serial number of the device is displayed by pressing the “N” key.
The serial number is only displayed and cannot be changed.
The serial number is entered during the manufacturing process.
After replacing the PCB Control CS_CI, during the power up sequence, the serial
number of the device has to be entered.
Terminate with the “X” key.
To Next Page
Loading...
