Marquette Hellige GmbH MAC 1100/1200 V 1.1 Page 7
227 492 20 D - 0002
1 Device description
This Service Manual describes device version V1.1 of MAC1100 and MAC1200.
The MAC1100 is a portable electrocardiograph with an integrated printing unit.
They are used to acquire, record and process ECG signals.
The integrated LCD graphics Display shows 3 ECG channels. It also displays status
information, filter settings, speed/format, gain and the status of the electrodes.
With the setup feature, the user is able to setup the device and the modes for his
own needs.
The MAC1100 offers 2 modes of operation: Automatic (12-lead) and Manual (6-
lead).
Transmission of one in the automatic mode aquired ECG to the MUSE or CardioSys
system directly or via a modem.
It is designed for line-power operation.
In addition, a NC-battery with a charging circuit can be integrated into the instrument
as a separate option.
In addition, a pump for the KISS system can be integrated into the instrument as a
separate option.
The patient cable for the acquisition of ECG signals is connected by means of a 15-
pin connector as used with MAC 500. Patient cables used with MAC 1000 cannot be
connected to the MAC 1200.
The MAC1200 has all features of the MAC1100, in addition, the following features
are included:
- NC battery with charging circuit is integrated in general
- Arrhythmia as third mode of operation
- Automatic mode with CSI protocol for transmission
- Automatic mode with interpretation (Option)
- Automatic mode with storage for up to 40 ECGs (option)
The acquired ECGs can be transmitted to MUSE or CardioSys directly or via a
Modem.
MAC1100/1200 with version V1.1 has all features of the version V1.0 described
above, additionally version V1.1 has a Remote Start Input, an internal Modem
Power Supply (MAC1200 US device only) and the new Software Release V5.1.
To Next Page
Loading...
Need help?
General
