GE MI-869 - Page 105

CHAPTER 3: INTERFACES SOFTWARE INTERFACE
869 MOTOR PROTECTION SYSTEM – INSTRUCTION MANUAL 3–33
2. Select the Maintenance > Update Firmware menu item. The following screen
appears. Select OK to proceed.
3. The EnerVista 8 Series Setup software requests the new firmware file. Locate the
folder that contains the firmware file to load into the 869.
The firmware filename has the following format.
The following screen appears. Select YES to proceed.
4. EnerVista 8 Series Setup software now prepares the 869 to receive the new firmware
file. The 869 front panel momentarily displays “Upload Mode”, indicating that it is in
upload mode.
J2 J08 A A
150 . SFD
File type
Board Assembly Rev #
Code Type in Memory Device
PCB Code Number
Product Reference Code (J0=8 Series)
Firmware Rev #