GE MM200 Quick Start Guide

28 MM200 MOTOR MANAGEMENT SYSTEM – QUICK START GUIDE
USER INTERFACE SPECIFICATIONS CHAPTER 6: SPECIFICATIONS
GROUND FAULT (CBCT)
Pickup level:........................................................... 0.5 to 15.0 A in steps of 0.1 A
Trip time delay on start:................................... 0 to 10 s in steps of 0.1 s
Trip time delay on run: ..................................... 0 to 5 s in steps of 0.1 s
Alarm time delay on start/run:..................... 0 to 60 s in steps of 1 s
Timing accuracy: ................................................ ±100 ms or ±0.5% of total time
Elements:................................................................ trip and alarm
LOAD INCREASE
Pickup level:........................................................... 50 to 150% of FLA in steps of 1%
Timing accuracy: ................................................ ±500 ms
Elements:................................................................ Alarm
MECHANICAL JAM
Pickup level:........................................................... 1.01 to 4.50 × FLA in steps of 0.01
Time delay: ............................................................ 0.1 to 30.0 seconds in steps of 0.1
Timing accuracy: ................................................ ±500 ms
Elements:................................................................ trip
THERMAL MODEL
Standard curve time multiplier: ................... 1 to 15 in steps of 1
Thermal overload pickup:............................... 1.01 to 1.25 in steps of 0.01 x FLA
Motor full load current (FLA): ......................... 0.5 to 1000 A in steps of 0.1
Motor rated voltage: ......................................... 100 to 690 V AC
Curve biasing:....................................................... hot/cold ratio exponential running and stopped cooling
rates
Update rate:.......................................................... 3 cycles
Hot/cold safe stall ratio:.................................. 1 to 100% in steps of 1%
Timing accuracy: ................................................ ±200 ms or ±2% of total time (based on measured value)
Elements:................................................................ trip
THERMISTOR
Sensor types: ........................................................ PTC (R
HOT
= 100 to 30 kohms); NTC (R
HOT
= 100 to 30 kohms)
Timing accuracy: ................................................ ±500 ms
Elements:................................................................ Trip and alarm
UNDERCURRENT
Pickup level:........................................................... 1 to 100% of FLA in steps of 1
Time delay: ............................................................ 1 to 60 seconds in steps of 1
Timing accuracy: ................................................ ±500 ms
Elements:................................................................ Trip and alarm
POWER FAILURE RESTART
Type: ......................................................................... Digital input
Power failure time:............................................. 0 to 30 seconds in steps of 1
Restart time delay:............................................. 0 to 300 seconds in steps of 1
UV detection time accuracy:......................... ±100 ms or ±5%
User interface specifications
HAND HELD DISPLAY (HHD)
Size: ........................................................................... width 153mm, height 102mm, depth 35mm
LCD:........................................................................... 3.5-inch color, 320 by 240 pixels
LED Indicators:..................................................... 10 LEDs
Pushbuttons:......................................................... Start A, Start B, Stop, plus 11 LCD screen display control keys
Ports:......................................................................... USB 2.0 port for laptop computer connection
Cable - GCP to Base Unit: ............................... Shielded RJ45; Maximum length 6' (1.83m)

GE MM200 Specifications

General

Brand	GE
Model	MM200
Category	Control Unit
Language	English