5–34 MULTILINK ML1200 MANAGED FIELD SWITCH – INSTRUCTION MANUAL
IP ADDRESSING CHAPTER 5: IP ADDRESSING
Syntax telnet <IPv6 address> - telnet to an IPv6 station
Example – telnet fe80::220:6ff:fe25:ed80
Besides, if the end station supports IPv6 addressing (as most Linux and Windows systems
do), one can access the switch using the IPv6 addressing as shown in the example below
http://fe80::220:6ff:fe25:ed80
5.5.5 List of commands in this chapter
Syntax ipconfig [ip=<ip-address>] [mask=<subnet-mask>] [dgw=<gateway>] [add|del]
– configure an IPv6 address. The add/delete option can be used to add or delete IPv4/IPv6
addresses.
Syntax show ipconfig – display the IP configuration information – including IPv6 address
Syntax ping6 <IPv6 address> - pings an IPv6 station
Syntax show ipv6 - displays the IPv6 information
Syntax ftp <IPv6 address> - ftp to an IPv6 station
Syntax telnet <IPv6 address> - telnet to an IPv6 station.
To Next Page
Loading...
Need help?
General
