GE MultiLink ML1200 User Manual

9–6 MULTILINK ML1200 MANAGED FIELD SWITCH – INSTRUCTION MANUAL
PORT MIRRORING AND SETUP CHAPTER 9: PORT MIRRORING AND SETUP
Back pressure and flow control (continued)
ML1200(device)##
backpressure rxthreshold=30
Rx Buffer Threshold set successfully
ML1200(device)## show backpressure
Rx Buffer Threshold : 30
ML1200(device)## show port
Keys: E = Enable D = Disable
H = Half Duplex F = Full Duplex
M = Multiple VLAN's NA = Not Applicable
LI = Listening LE = Learning
F = Forwarding B = Blocking
Port Name Control Dplx Media Link Speed Part Auto VlanID GVRP STP
-------------------------------------------------------------------------------
1B1 E H 10TxUP10 NoE 1 - -
2 B2 E H 10Tx DOWN 10 No E 1 - -
3 JohnDoe E H 10Tx DOWN 10 No E 1 - -
4 JaneDoe E H 10Tx DOWN 10 No E 1 - -
5 B5 E F 100Tx UP 100 No E 1 - -
6 B6 E H 10Tx DOWN 10 No E 1 - -
ML1200(device)## show port=11
Configuration details of port 11
--------------------------------------------------
Port Name : JohnDoe
Port Link State : DOWN
Port Type : TP Port
Port Admin State : Enable
Port VLAN ID : 1
Port Speed : 10Mbps
Port Duplex Mode : half-duplex
Port Auto-negotiation State : Enable
Port STP State : NO STP
Port GVRP State : No GVRP
Port Priority Type : None
Port Security : Enable
Port Flow Control : Disable
Port Back Pressure : Disable
Port Link Loss Alert : Enabled
ML1200(device)## setport port=11 flow=enable bp=enable
(continued on next page)

GE MultiLink ML1200 Specifications

General

Brand	GE
Model	MultiLink ML1200
Category	Switch
Language	English