GE MultiLink ML1200

CHAPTER 5: IP ADDRESSING IP ADDRESSING
MULTILINK ML1200 MANAGED FIELD SWITCH – INSTRUCTION MANUAL 5–25
Z If the changes need to be ignored, click on Cancel and reboot the
switch.
Z If the changes need to be saved, click on OK.
The following figures illustrate saving changes made after adding an SNTP server. This is
done by clicking on the Save icon to save current configuration
5.4.7 Host Names
Instead of typing in IP addresses of commonly reached hosts, the ML1200 allows hosts to
be created with the necessary host names, IP addresses, user names, and passwords.
Z Use the Configuration > Access > Host menu to create host entries
as shown below.