GE MultiLink ML1200 - 17.8 Command Reference

17–14 MULTILINK ML1200 MANAGED FIELD SWITCH – INSTRUCTION MANUAL
MISCELLANEOUS COMMANDS CHAPTER 17: MISCELLANEOUS COMMANDS
17.8 Command Reference
17.8.1 Main Commands
The main commands can be categorized as show commands, set commands, and
context-less commands. The show commands are listed below.
•
show active-snmp: displays currently active SNMP support
•
show active-stp: displays currently active STP
•
show active-vlan: displays currently active VLAN
•
show address-table: displays address table parameters
•
show age: displays the address table age limit
•
show arp: displays the arp details
•
show bootmode: displays the current bootmode value
•
show broadcast-protect: displays broadcast storm protection parameters
•
show config: displays the saved configuration as a whole or by module
•
show console: displays console serial link settings
•
show date: displays system date
•
show daylight: displays the configured daylight savings settings
•
show gateway: displays the gateway of the system
•
show gvrp: displays the GVRP parameters
•
show host: displays the host table for FTP users
•
show igmp: displays the IGMP parameters
•
show interfaces: display the interface information
•
show ip: displays the system IP address
•
show ip-access: displays the IP address access list
•
show ipconfig: displays the IP configuration
•
show lacp
•
show lll: displays the Link-Loss-Learn parameters
•
show log: displays log information
•
show logsize: displays the current event log size
•
show mac: displays the system MAC address
•
show modbus: displays Modbus settings
•
show modules: displays the module information
•
show port: displays the port information
•
show port-mirror: displays the port mirroring parameters
•
show port-security: displays the port security configuration parameters
•
show power: displays condition of power supplies, in redundant power supply
switches only
•
show qos: displays the QOS settings
•
show rmon: displays the rmon configuration parameters
•
show setup: displays the setup parameters of the system