GE MultiLink ML1200

13–14 MULTILINK ML1200 MANAGED FIELD SWITCH – INSTRUCTION MANUAL
RAPID SPANNING TREE PROTOCOL CHAPTER 13: RAPID SPANNING TREE PROTOCOL
romode <enable|disable>
romode show
The sequence of commands for enabling ring-only mode is shown in the following
example:
Example 13-5: Configuring smart RSTP, ring-only mode
ML1200# rstp
ML1200(rstp)##rstp enable
Successfully set the RSTP status
ML1200(rstp)##
romode show
RO-MODE status : Disabled
RO-MODE set on ports : NONE
ML1200(rstp)##
romode add port=1,2
Added Ports: 1,2
ML1200(rstp)##
romode enable
RSTP Ring Only Mode Enabled.
ML1200(rstp)##
romode show
RO-MODE status : Enabled
RO-MODE set on ports : 1,2
ML1200(rstp)##
romode disable
RSTP Ring Only Mode Disabled.
ML1200(rstp)##
romode show
RO-MODE status : Disabled
RO-MODE set on ports : 1,2