CHAPTER 13: RAPID SPANNING TREE PROTOCOL RAPID SPANNING TREE PROTOCOL
MULTILINK ML1200 MANAGED FIELD SWITCH – INSTRUCTION MANUAL 13–21
Z Once in Edit mode, change the Status to Enable.
Z Save Configuration.
To reset RSTP back to normal mode, select “Normal RSTP” for the Protocol setting. Save the
configuration by clicking on the icon.
Z Select the Configuration > RSTP > RO Mode menu as shown below:
Z Click the Edit button to configure RO Mode.
Z Select the desired ports as shown below, then click OK to exit.
ENABLE STATUS...
...THEN SAVE
To Next Page
Loading...
