GE MultiLink ML1200

17–18 MULTILINK ML1200 MANAGED FIELD SWITCH – INSTRUCTION MANUAL
MISCELLANEOUS COMMANDS CHAPTER 17: MISCELLANEOUS COMMANDS
The port mirroring commands are shown below. Refer to Chapter 9 - Port Mirroring and
Setup for additional details.
•
help port-mirror
•
prtmr: enables/disables port mirroring functionality
•
setport: defines the port mirroring ports
The port security commands are shown below. Refer to Chapter 6 - Securing Access for
additional details.
•
action: sets the action type of secured port
•
allow: allows MAC addressing per port
•
help port-security
•
learn: enables/disables security for a single port or group of ports
•
ps: enables/disables security in system
•
remove: removes MAC addressing per port
•
signal: sets the signal type of the secured port
The quality of service (QoS) commands are shown below. Refer to Chapter 14 - QoS
Overview for additional details.
•
help qos
•
setqos: configures QOS configuration usage
•
set-untag
•
set-weight: sets the port priority weights for all the ports in all the device
•
show-portweight: displays the current port weight priority
The remote monitoring (RMON) commands are shown below. Refer to Chapter 16 -
Configuring RMON for additional details.
•
alarm: sets the owner for the alarm group
•
event: sets the owner for the event group
•
help rmon
•
history: sets the owner for the history group
•
statistics: sets the owner for the statistics group
The Rapid Spanning Tree Protocol (RSTP) commands are shown below. Refer to Chapter 13
- Rapid Spanning Tree Protocol for additional details.
•
cost: sets the path cost of ports
•
forceversion: set the force version of STP
•
help rstp
•
lll
•
port: sets the RSTP administration status of ports
•
priority: changes the priority of ports or bridge
•
rstp: changes the RSTP administrative status of the bridge
•
show-forceversion: shows the current force version of RSTP
•
show-mode: shows the port mode status
•
show-timers: shows the bridge time parameters
•
timers: changes the bridge time parameters