GE NX-10

LOC DESCRIPTION DEFAULT PROGRAMMING DATA
67
ACCOUNT NUMBER FOR PARTITION 4 00000000
68-87
RESERVED
88
AUTOMATION SYSTEM PORT 9997
AUTOMATION EVENT TRANSITIONS
SEGMENT 1
1 Reserved
2 Interface configuration message
3 Reserved
4 Reserved
5 1 zone status message
6 16 zone snapshot message
7 1 partition message
8 8 partition snapshot message
SEGMENT 2
1 System status message
2 X10 message received
3 Log event message
4 Keypad message received
89
5-8 Reserved
AUTOMATION REQUEST / COMMANDS
SEGMENT 1
1 Reserved
2 Interface configuration message
3 Reserved
4 Zone name request
5 1 zone status request
6 16 zone snapshot request
7 1 partition request
8 8 partition snapshot request
SEGMENT 2
1 System status request
2 Send X10 command
3 Log event request
4 Send keypad text command
5 Keypad terminal mode request
6 Keypad tone broadcast
7-8 Reserved
SEGMENT 3
1 Program data request
2 Program data command
3 User info request with PIN
4 User info request without PIN
5 Set user code command with PIN
6 Set user code command without PIN
7 Set user authorization command with PIN
8 Set user authorization command without PIN
SEGMENT 4
1 RF transmission request
2 Clock / calendar request
3 Store communication event request
4 Set clock / calendar command
5 Primary keypad function with PIN
6 Primary keypad function without PIN
7 Secondary keypad function
90
8 Zone bypass toggle
91
KEYPAD ADDRESS FOR AUTOMATION TEXT RETRIEVAL 192
92-
125
RESERVED
The following programming locations are only available with Version 2.09 and higher (microprocessor code).