– 34 –
Side Panel Removal
The procedures to remove both the left and right
side panels are identical.
Disconnect power to the range.1.
Remove the oven door and warming drawer. 2.
(See Oven DoorAssembly, Warming Drawer
Assembly.)
Remove the range from its installation.3.
Raise and support the cooktop or remove the 4.
cooktop. (See Cooktop Assembly.)
Remove the 1/4-in. hex-head hidden screw 5.
located in the recess near the front leveling leg.
6. Remove the three 1/4-in. hex-head screws from
the rear of the side panel.
Maintop Strike
Note: The front of the panel is held to the range
frame by 2 plastic grommets that engage 2 keyhole
slots placed along the inside front fl ange of the
panel.
9. Grasp the front and rear portion of the side
panel. Lift the side panel up and pull towards
you, then disengage the two plastic grommets.
Plastic Grommet
Plastic Grommet
Grommet
Engaged (A)
Grommet
Disengaged (B)
A
B
7. Remove the T-15 Torx screw and the 1/4-in hex-
head screw from the top of the side panal.
8. Remove the Phillips-head screw and maintop
strike from the top of the side panel.
Recess
To Next Page
Loading...
