GE Profile PHB925SB1SS - Induction System Failure Codes; Induction Failure Code List and Causes

– 60 –
F790 Main Logic Board internal touch key Replace Main Logic Board.
chip signal error
F7A0 Main Logic Board internal touch key Replace Main Logic Board.
chip memory error
F7B0 Main Logic Board internal touch key Replace Main Logic Board.
chip memory error
F800 Main Logic Board memory error Replace Main Logic Board.
F810 Main Logic Board memory error Replace Main Logic Board.
F820 Main Logic Board EEPROM memory Replace Main Logic Board.
error
F90x Door Lock Unlock-Home signal a) Lock motor cam switch faulty/loose.
became untrue during cooking b) Harness from lock motor to RPSM J16 open.
NOTE: Control will open/close relay several
times trying to “jog” the motor.
F91x Door Lock Lock-Home signal
became untrue during clean
F92x Both the Lock-Home and a) Lock motor cam switch is stuck closed.
Unlock-Home switches are closed Replace assembly.
simultaneously b) Insulation wrapped around cam.
c) Replace RPSM Main Board.
FA00 Device not found within Induction a) Fix open signal harness within cooktop.
Cooktop module b) Replace filter, bridge or generator board.
FA10 Induction cooktop – bridge board Replace induction bridge board.
error
FA30 Induction cooktop – fan error a) Replace cooktop fan.
b) Replace cooktop bridge board.
FA40 Induction cooktop – generator Replace both cooktop generator boards.
board error
FA47 Enable signal not getting from Main a) Check harness connection.
Logic Board J241 pin 8 to Cooktop b) Replace bridge board.
Bridge Board X200 pin 3 c) Replace Main Logic Board.
FA5x Induction cooktop burner sensor a) Transient error – wait for cooldown.
too hot (F-code not logged) b) Replace cooktop coil sensor.
FA6x Induction cooktop – filter board a) Check power connections on filter board.
error b) L1 or L2 from line is faulty.
c) Replace cooktop filter board.
FA7x Induction cooktop generator board Replace cooktop generator board.
temperature sensor open or DC
problem
FA8x Induction cooktop – comm error a) Check signal harness in cooktop module.
from cooktop filter to other cooktop b) Replace filter board.
boards
FA9x Induction cooktop – coil a) Coil sensor harness.
temperature sensor break b) Replace cooktop coil sensor.
c) Generator board.
FAAx Induction cooktop – unsuitable a) Transient error – use correct pot size.
pot size b) Coil fell away from glass.
Induction Failure Codes
Induction Element Locations: 0= Left Front, 1= Left Rear, 2= Right Front, 3= Right Rear