– 37 –
Note: When reinstalling the sensor, use a small fl at-
blade screwdriver to push and guide the sensor wire
harness into the oven liner.
Broil Element
The broil element will not work if the •
temperature probe is plugged in.
• The broil element is located on the back wall of
the oven. The oven sensor must be removed to
access the broil element.
The broil element is rated at 3800 watts and has
an approximate resistance value of 15 Ω. When
energized, the broil element will draw approximately
15 amps.
To remove the broil element:
Remove the 1/4-in. hex-head screw that 1.
attaches the sensor to the back of the oven
cavity. (See Oven Temperature Sensor.)
Remove the four 1/4-in. hex-head screws that 2.
hold the broiler to the oven cavity.
Broil Element
3. Carefully pull, then lower the broiler element
towards the front of the oven.
4. Disconnect the wires from the broiler element.
Disconnect
Disconnect
Note: Upon reassembly, ensure displaced insulation
around oven and components is returned to its
original position.
Note: Upon reassembly, ensure displaced insulation
around oven and components is returned to its
original position.
To Next Page
Loading...
