– 46 –
Warming Drawer Element
• The warming drawer element is rated at 400
watts, has an approximate resistance value of
36 Ω, and draws approximately 3.3 amps.
• The element is located on the fl oor of the
warming drawer compartment. The element
terminals are located behind the element
terminal cover.
To remove the warming drawer element:
Disconnect power to the range.1.
Remove the range from the installation.2.
Remove the three 1/4-in. hex-head screws and 3.
the element terminal cover from the back of the
range.
4. Disconnect the 2 element wires.
5. Remove the two 1/4-in. hex-head screws that
attach the element to the back wall.
6. Using a fl at blade screwdriver, lift the tabs on
each of the 2 clips and remove the element.
Cover
Disconnect
Disconnect
Clip
Warming Drawer Temperature Characteristics
Hi Warmer On Time 90 seconds
Warmer Off Time 119
seconds
100% First Rise On Time 900
seconds
Std Warmer On Time 78 seconds
Warmer Off Time 131
seconds
100% First Rise On Time 850
seconds
Lo Warmer On Time 66 seconds
Warmer Off Time 142
seconds
100% First Rise On Time 800
seconds
Warming drawer temperatures are controlled by
duty cycling algorithms.
Low Temperature = 165° +/- 25°F.
Standard Temperature = 175° +/- 25°F.
High Temperature = 180° +/- 25°F.
To Next Page
Loading...
