ā 48 ā
Glass Touch Panel
To remove the glass touch panel:
Remove the main logic board. (See 1. Main Logic
Board.)
Remove the 1/4-in. hex-head screw that 2.
attaches the control panel ground wire.
3. Place the control panel in the service position.
(See Control Panel.)
4. Remove the four 1/4-in. hex-head screws that
attach the touch panel brackets to the control
panel frame.
5. Disconnect the left and right touch panel ribbon
connectors from the glass touch panel.
6. Lift glass touch panel from control panel frame.
Ribbon Connector
Glass Touch Panel Removed
Ribbon Connector
To Next Page
Loading...
