ā 49 ā
Cooktop Components
Aluminum Plate
To remove the aluminum plate:
Remove the cooktop assembly. (See 1. Cooktop
Assembly.)
Place the cooktop topside down on a protective 2.
surface.
Remove the seven 3/8-in. hex-head nuts and 3.
spacers.
4. Slide the seven carriage bolts out of the keyed
slots in the cooktop.
5. Lift the aluminum plate from the cooktop.
Note: When installing the aluminum plate to the
cooktop, be sure to install spacers with the shoulder
toward cooktop.
Carriage Bolt
Shoulder
Bridge Board
The bridge board is located under the cooktop and
attached to the aluminum plate with 4 compression
pins. Three wire harnesses are connected to the
board. It is necessary to remove the aluminum plate
to access the bridge board. (See Aluminum Plate.)
Disconnect
To Next Page
Loading...
