– 35 –
4. Remove the main PCB.
5. Remove the relay board and mounting.
6. Remove 6 air cover screws.
GEA00457
ScrewsScrews
GEA00458
ScrewsScrews
7. Remove 4 screws from the lamp cover.
GEA00459
Halogen Lamp
Housing Screws
Halogen Lamp
Housing Screws
8. Remove the control panel (see page 31).
9. Remove the oven cavity lamp assembly (see
page 28).
10. Disconnect 4 wire leads from the upper
thermostat.
GEA00460
Upper Halogen T.C.O.sUpper Halogen T.C.O.s
11. Straighten 8 tabs that secure the reflector to
the halogen cover.
12. Carefully lift the cover off the lamps.
Caution: Do not touch the halogen lamps. Dirt
and skin oil can cause the lamps to explode
when turned on.
Note: The two upper halogen lamps are replaced
as a pair.
GEA00461