Chapter 3. Programming Site Data
Transport® Model PT878 Portable Liquid Flowmeter User’s Manual 23
3.2 Entering Transducer Parameters
To enter the Transducer option, scroll to the Transducer entry on the
Program Menu and press
[ENTER]. The screen appears similar to Figure 10
below. To step through each parameter, press the [
T] key. Refer to
Figure 143 on page 227 of Appendix A.
Note: Refer to the Liquid Transducer Installation Guide (916-055) for
additional information about transducers and configurations.
.
Figure 10: Transducer Option Window
1. The first prompt asks you to select whether you are using a wetted or a
clamp-on transducer.
a. Use the [W] and [X] keys to scroll between the two types.
b. Press [ENTER] to confirm the choice.
Transducer
Pipe
Lining Path
Transducer/Pipe
OK
Cancel
Fluid
Type: Wetted
Clamp-on
Transducer
Special
Frequency
2.00
Tw
14
MHz
Wedge Ang
50
°
Wedge Tmp
25
°C
Wedge SS
1219.2
m/s
µs
To Next Page
Loading...
