GE Transport PT878 - Entering Custom Cp Data in the Energy Option

Chapter 3. Programming Site Data
46 Transport® Model PT878 Portable Liquid Flowmeter User’s Manual
3.7.1 Entering Inputs in the Energy Option (cont.)
• To confirm the entries and return to Operate mode, press [F3] (OK). The
PT878 returns to Operate Mode.
• To leave the window without confirming the entries, press [F2] (Cancel)
or the
[ESC] key. The PT878 returns to Operate Mode.
To enter data for Custom Cp calculations, proceed to the Custom Cp tab,
discussed on page 46.
3.7.2 Entering Custom Cp Data in the Energy Option
To program Custom Cp tables in the Energy Option, return to the tabs at the
top of the Energy Option window. Press the [X] arrow key until you have
highlighted the Custom Cp tab, and press
[ENTER]. The screen appears
similar to Figure 23 below. To step through each parameter, press the [T]
key.
Figure 23: Custom Cp Tab in the Energy Option
Energy Options
Cancel
OK
Energy Option Inputs
90
Custom Cp
Custom Cp
Fixed
Table
Density Table
Static Density
Edit Table
Density Source
Edit Table