Chapter 3. Programming Site Data
Transport® Model PT878 Portable Liquid Flowmeter User’s Manual 51
3.8.1 Entering General-Purpose Analog Inputs (cont.)
2. The next prompt asks if you want to label the input.
a. Press [ENTER] to enter the text box. The text creation window
appears, as shown in Figure 27 below.
Figure 27: Text Creation Window
b. Use the four arrow keys to scroll to the desired letter or symbol, and
press
[ENTER] to add the letter to the name.
Note: Pressing [SEL] causes the screen to show successively a set of
upper-case (capital) letters, a set of lower-case letters, and a set of
symbols. Use all three screens to create a desired label.
c. Repeat this procedure for each letter or symbol you wish to add to
the name. If you wish to delete a letter, press
[F1] (Delete) to erase
each letter or symbol, from right to left on the label.
d. When you have completed the label, press [F3] (OK) to confirm the
label, or
[F2] (Cancel) to leave the window without adding the label.
A B C D E F G H I J
K L M N O P Q R S T
U V W X Y Z 0 1 2 3
4 5 6 7 8 9 . , “ ‘
= < >
Delete
Cancel OK
To Next Page
Loading...
