GE Transport PT878 - Chapter 4. Creating and Managing Sites

Chapter 3. Programming Site Data
Transport® Model PT878 Portable Liquid Flowmeter User’s Manual 55
3.9 Entering the Analog Output (cont.)
2. The next prompt asks you to select the analog output type from a list of
choices, as shown in Figure 30 below.
Figure 30: Data Source Selection Window
a. Press [ENTER] to open the window.
b. Scroll to the desired output type.
c. Press [SEL] to confirm your selection.
d. The prompt then moves to a list of unit types. (The available units
depend on the selection made at the Data Source prompt.) Scroll to
the desired output unit.
e. Press [F3] (OK) to confirm your selection.
Select Measurement
Cancel OK
Diagnostics
Aux Input A
Volume
No Unit
Velocity
UserFunction
Meters/sec
Feet/sec
Temperature
Power
Test
Aux Input B