Measurement and Analysis
Versana Essential – User Guide 2-63
5759238-100 English Rev. 2
TAMAX and TAMEAN
Manual Trace
The value measured depends upon the Vol Flow Method preset.
The two selections available are: Peak (TAMAX) and Mean
(TAMEAN).
To do a manual trace of TAMAX or TAMEAN:
1. Press Measure key in Measure mode to select Trace.
Select Manual or in the Utility -> Measure - Advanced
preset menu set Trace preset to Manual.
2. To position the caliper at the trace start point, move the
Trackball.
3. To fix the start point, press Set.
4. To trace the maximum values of the desired portion of the
spectrum, move the Trackball.
NOTE: To edit the trace line, move the Trackball.
5. To complete the measurement, press Set. The system
displays the measurement values in the Results Window.
To Next Page
Loading...
