Getting Started
1-38 Versana Essential – User Guide
5759238-100 English
Rev. 2
Power Off
To power off the system:
1. When you shutdown the system, enter the scan screen and
lightly press the Power On/Off switch at the front of the
system once. The System-Exit window is displayed.
NOTE: DO NOT press and hold down the Power On/Off switch to
shutdown the system.
2. Using the Trackball, select Shutdown.
The shutdown process takes a few seconds and is
completed when the Power On/Off switch illumination turns
from green to blue.
NOTE: DO NOT select Exit for Shutdown. Exit is only available to
Service representative.
NOTE: If the system has not fully shut down in 60 seconds in the
power-off sequence, press and hold down the On/Off switch
until the system shuts down.
3. Disconnect the probes.
Clean or disinfect all probes as necessary. Store them in
their shipping cases or another appropriate probe storage
system to avoid damage.
4. Disconnect the power plug from the power outlet.
DO NOT turn off the circuit breaker before the monitor
display turns off.
Data may be lost or system software damaged if the circuit
breaker is turned off before the system shuts down.
To Next Page
Loading...
