Getting Started
1-48 Versana Essential – User Guide
5759238-100 English
Rev. 2
Entering a Patient List
All patient information can be entered before starting an exam.
1. Press Patient to display the Patient Screen.
2. Press New Patient to erase the current patient data.
3. Select Store All if data from previous patient was not saved.
4. Enter the Patient ID.
5. Enter the patient and exam information.
6. Press Register.
7. Repeat above steps as required.
Select the patient from the Patient List. Select Resume Exam to
continue the last exam that was performed on the selected
patient.
Select New Exam to start a new exam on the selected patient.
Starting a new exam on an existing patient
1. Select Patient on the control panel.
2. Select the patient from the Patient List.
3. Select New Exam.
4. A new exam is created. Enter the data and begin the scan.
To Next Page
Loading...
