GE Versana Essential - Cleaning the System

After The Exam Is Over
3-32 Versana Essential – User Guide
5759238-100 English
Rev. 2
Cleaning the system
Prior to cleaning any part of the system:
1. Turn off the system power. Disconnect the power cord. See
‘Power Off’ on page 1-38 for more information.
System Cabinet
To clean the system cabinet:
1. Moisten a soft, non-abrasive folded cloth with a mild,
general purpose, non-abrasive soap and water solution.
2. Wipe down the top, front, back, and both sides of the system
cabinet.
NOTE: Do not spray any liquid directly into the unit.
Operator Control Panel
To clean the operator control panel:
1. Moisten a soft, non-abrasive folded cloth with a mild,
general purpose, non-abrasive soap and water solution.
2. Wipe down operator control panel.
3. Use a cotton swab to clean around keys or controls. Use a
toothpick to remove solids from between keys and controls.
NOTE: When cleaning the operator control panel, make sure not to spill
or spray any liquid on the controls, into the system cabinet, or in
the probe connection receptacle.
NOTE: In case of SARS, use bleach, alcohol, or Cidex in a normal
diluted form for cleaning/disinfecting the operator panel.
NOTE: DO NOT use T-spray or Sani Wipes on the control panel.
WARNING
Ensure that you follow the cleaning procedure and use the
cleaning agents provided in this manual.