Moving the system
Versana Essential – User Guide 1-25
5759238-100 English Rev. 2
Before moving the system (continued)
1. Press the Power On/Off switch to power off the system.
See ‘Power Off’ on page 1-38 for more information.
2. Unplug the power cord.
3. Wind the power cable around the rear handle.
NOTE: To prevent damage to the Power Cord, DO NOT pull
excessively on the cord or make sharp bends while
wrapping.
4. All cables from off-board peripheral devices and the
ethernet connection must be disconnected from the
console.
5. Ensure that no loose items are left on the console.
6. Connect all probes to be used while off site. Ensure that
probe cables are out of the way from the wheels and not
protruding beyond the console. Use the probe management
hooks located below the Control Panel to further secure the
probe cables.
7. Store all other probes in their original cases or in soft cloth
or foam to prevent damage.
8. Store sufficient gel and other essential accessories in the
provided space.
9. Flip down the monitor.
10. Disconnect the footswitch from the console.
11. Unlock the wheels.
To Next Page
Loading...
