GE
D
IRECTION GB091046, REVISION 2 VIVID E9 / VIVID E7 BT’13 SERVICE MANUAL
8 - 12 Section 8-4 - Reloading the software
8-4-9 Reloading the Software from Repository
8-4-9-1 Introduction to Software Reload from Repository
During the installation process, when the software was installed on the VIVID E9 / VIVID E7, the
compressed original files, from the UFD or DVD and CD, were stored on a separate disk partition on the
hard disk drive, labeled “REPOSIT” (Repository). If you are going to reinstall the software, you can
install from these files. Usually, when reinstalling the software on the same HDD, you don’t need to copy
the files from UFD or DVD/CD once more!
8-4-9-2 Preparations
Disconnect all external USB devices before starting the reload. (This is to ensure that the drive letters
are not mixed up during the software reload.)
To Next Page
Loading...
