GE Vivid E7 - Page 409

GE
D
IRECTION GB091046, REVISION 2 VIVID E9 / VIVID E7 BT’13 SERVICE MANUAL
Chapter 8 - Replacement procedures 8 - 93
8-6-7-3 Install the Frame w/LCD and Touch Screen
1.) Place the Upper Bezel, with the front down on a clean, antistatic surface.
2.) Install the Frame w/LCD and Touch Screen so it aligns with the fixing screw holes on the Upper
Bezel.
3.) Install the fixing screws.
NOTE: Be careful so you don’t bend the EMC fingers (see: Figure 8-82) when installing the LCD Cover.
4.) Install the LCD Cover.
5.) Install the five (5x) fixing screws.
6.) Install the Operator Panel, Upper.
7.) Install the Control Knobs.
8-6-7-4 Calibration and adjustments
Run the Touch Screen Calibration in section Section 6-5 "Touch Screen Calibration" on page 6-10.
Figure 8-82 EMC fingers
Figure 8-83 Position for screws
EMC FINGERSEMC FINGERS
PROTRUDING TABS
(NOT VISIBLE IN THIS ILLUSTRATION)