GE Vivid E7 - Page 568

GE
D
IRECTION GB091046, REVISION 2 VIVID E9 / VIVID E7 BT’13 SERVICE MANUAL
8 - 252 Section 8-11 - Back End Processor (BEP) parts replacement
8-11-4-5 Installing the Graphics Adapter in the BEP6 (cont’d)
6.) Install the BEP Cover as described in these steps:
a.) Insert the base of the BEP Cover inside the base of the BEP.
Be sure the bottom lip of the BEP Cover rests inside the BEP.
b.) Tilt the top of the BEP Cover toward the VIVID E9 / VIVID E7.
c.) Install the fixing screw(s) for the BEP Cover:
- On BEP6 there are two finger screws on the top of the BEP Cover.
7.) Replace the Left Side Cover.
8.) Connect the Mains Power Cable to the wall outlet.
9.) Power up the VIVID E9 / VIVID E7.
NOTICE
Be careful not to pinch any of the cables when installing the BEP Cover.