TOOLSYOUWILLNEED
Phillipsand flat-blade screwdrivers
Penciland ruler
Twopipe wrenches(one for backup)
Open-endor adjustable wrench
Nut driver or wrench. 1/4"
DnTl
ADDITIONAL MATERIALSYOUMAY NEED:
Gaslineshut-off valve
Pipejolbt sealantor UL-approvedpipe threadtape with
Teflon*that resistsaction ofnatural and LPgases.
*Teflon.Registeredtrademarkof DuPont
Flexiblemetal apphanceconnector(1/2" LD.).A 5-foot
lengthis recommendedfor ease of installation but other
lengthsareacceptable.Neverusean o/dconnector when
lbstalhbga new range.
Flareunionadapterforconnectiontogassupplyline
(3/4" or 1/2" NPTx1/2" LD.)
Flareunionadapterforconnectiontopressureregulator
onrange(1/2" NPTx1/2" LD.)
Liquidleakdetectororsoapywater
Lagboltor 1/2" O.D.Sleeveanchor(forconcrete
floorsonly).
SqueezeConnectormatchingthesloeofthebracket
opening(ontherangebackbehindthe wkingcover)andthe
houseconduitObtainonlyif replacingthepowercordwith
conduit
LOCATIONGUIDELINES
Do not locate the range where it may be subject to strong drafts. Any openings in the floor or waft
behind the range should be sealed. Make sure the openings around the base of the range that
supply fresh air for combustion and ventilation are not obstructed by carpeting or woodwork.
Your range, like many other household items,
is heavv and can settle into soft floor coverings
such as cushioned vinyl or caq)eting. Use care
when moving tile range on this t,ipe of flooring.
It is recommended that tile following simple and
inexpensive instructions be followed to protect
VO/II" _100I;
Tile range should be installed on a sheet _ff
plywood (or similar material). When tile floor
covering ends at tile fl'ont of tile range, tile area
that tile range will rest on should be built up
with plywood to tile same level or higher than
tile floor covering.
This Mll allow tile range to be moved t_r cleaning
or servicing. _Mso, make sm'e yam" floor covering
will withstand 180°E (See the Installation Safety
Instructions section.)
Make sure tile wall coverings arotmd your range
can withstand the heat generated (up to 200°F)
bv tile range. (See tile Installation Safety Instructions
section.)
IMPORTANT!
Remove aft tape and packaging. Make sure the burners are properly seated and level.
Take the accessory pack out of the oven.
Check to be sure that no range parts have come loose during shipping.
41
To Next Page
Loading...
