Installationof the range.
Read these instructions completely and carefully.
[] Replace the Power Cord (Optional) Continued
Perform this step only if the power cord shipped on the range does not match your wall receptacle.
[] 3-Wire Power Cord Installation Option
[]
[]
[]
[]
[]
[]
WARNIN& Theneu ,./or roun,wire
of the power cord must be connected to the neutral
t_rmba/ located b tile center of the term/)_a/ b/ock.
The power/eads must be conned_d to the b_vvr bft
and the lower dghttermba/s of the terminal b/ock.
]_wer ba ck of t]_e ];_m_ge.
I x}ose]/ the iq)per ce]/ter screw ore) the
termim_] block.
Slide t]_e ope_ slotted e]l(;[ of t]_e grom]d
st_:q) raider the iq)per ce]_ter sc_"e_r ()_ the
termh_a] block Make slate the groined strop
is a]] the way agaim]st the Iq)per cel_ter screw
amid tighte]_ it h_ place.
Place the grom]d plate (remo',ed eaHier)
over the bottom o{ the groined st_q:), press
them agaim_st the _:mge Jt}:m_e m_d attach
t]_e]'_ _,_it]_ the gl'o_H_d sere'>, (rei'_oved
h]sert the _ew [)ower cord thro_tg]], the
st];d_ re]ieL _]]ow e_ough slack to easi]}
attach the wires to the termim_] block.
hlsert the 3 termiml] screws (removed
earlier) thro_@_ each power cord termim_]
_J_g a_d h_to the lower tem_hm]s o[ the
termh_a] block Be certah_ that the ce]_ter
_ire (*_hite/_eut_:d) is com_ected to the
ce]_ter ]o_aer positio]_ of the termh_a] block
Tightel_ scre_s secm'e]y (approximately 20
h_ch-]bs.) i_to d_e tem_hm] block
Terlrfinalblock
(appearance
mayvary)
Neutral
Ground
plate Groundstrap
Power
Groundstrap
"X _ Openslottedend
[] Secm'e the strai_] relief i_l [)]ace i_l the
bracket b} tighte_i_g the st]:_i_ re]ie{ screws.
46
To Next Page
Loading...
