2 Safety
2.1 Intended use
The sampling valve type I is intended for drawing samples of liquids and viscous
media.
Hint!
The manufacturer will not accept any liability for damage resulting
from any use of the valve which is not in accordance with the
designated use of the valve. The risk is borne solely by the operating
company.
2.1.1 Requirements for operation
The prerequisite for reliable and safe operation of the component is proper
transportation and storage as well as professional installation and assembly.
Operating the unit within the limits of its designated use also involves adhering to
the operating, inspection and maintenance instructions.
2.1.2 Pressure equipment directive
The component is a piece of pressure equipment (without safety function) in the
sense of the pressure equipment directive: Directive 2014/68/EG. They are
classified according to Annex II, article 4, section 3. In the event of any
deviations, GEA Tuchenhagen GmbH will supply a specific Declaration of
Conformity.
2.1.3 Improper operating conditions
The operational safety of the component can not be guaranteed under improper
operating conditions. Therefore avoid improper operating conditions.
The operation of the component is not permitted if:
•
Persons or objects are in the danger zone.
•
Safety devices are not working or were removed.
•
Malfunctions have been detected on the component.
•
Damage to the component has been detected.
•
Maintenance intervals have been exceeded.
•
Clamp connections or screw fastenings on the housing are not properly
fastened and secured against accidental loosening.
2.2 Operator’s Duty of Care
The operating company of the component has a special responsibility for the
proper and safe handling of the component within their company. Only use the
component when it is in perfect operating condition in order to prevent danger to
persons and property.
Safety
Intended use
430BAL008583EN_1
12.08.2019 9
To Next Page
Loading...
Need help?
General
