MC-MP-SBD O wner’s Manual
39
Ozonator
Depending on system configuration, the ozonator can be on
during the filtering cycle, always on or it may operate at the same
time as the circulation pump. If a pump, blower or spa light is
turned on manually, the ozonator automatically turns off and
comes back on 40 minutes after last active output has been
turned off. On models without circulation pump, the ozonator
comes on only during filter cycles.
Depending on system configuration,the circulation pump could be
either on all the time or when heating and filtering only, except if
the system has been programmed to Stand-By mode with the
On/Off key. If the spa is turned off while heater is still on, the
circulation pump will continue to run for 30 seconds to allow
heater to cool down.
Following a power failure, the display panel will continue flashing
until any key is pressed. This feature notifies you that a power
failure has occurred.
The MC-MP-SBD is equipped with a sensor that monitors the air
temperature in the plumbing beneath the spa. If the system
detects air cold enough to freeze water in the pipes, it will activate
the Smart W inter Mode for a 24-hour period. In this mode, if
pumps have not been turned on within 2 hours, the system
automatically turns them on for 1 minute to prevent water from
freezing in pipes.
When pumps are operating in Smart Winter Mode, the "Filter"
indicator will flash on the display.
Circulation
Pump
Power-Up
Detection
Smart Winter
Mode
Temperature
Display Unit
The water temperature can be displayed in Fahrenheit (°F) or
Celsius (°C) degrees. To toggle between °F and°C, simply press
and hold
Light key for 5 seconds.
M C-M P-SBD Features
Operating Instructions
To Next Page
Loading...
Need help?
General
