3 Printer Setting
3.1 Printer Speed
Set the running speed of printer as 1000 in the printer settings in order to avoid collision because of
high speed during the test. After follow-up tests are completed it can be changed back to the original
value. (Recommend speed of Z-axis should not be too high, 1000 is OK)
Travel feed rate: 1000mm/min
Z-Axis feed rate: 1000mm/min
3.2 Number of Extruder and Nozzle Diameter
The number of extruder is set as 1. The diameter of print head is set according to the actual
To Next Page
Loading...
