Template Date: 1997_02_12
STEP 9
G0905046
Loosen the two axle mounting bolts located in back
of the axle. Do not remove the nuts at this time.
STEP 10
G0905033
G0905054
Remove the protective plug (1) and install an eye-bolt
(2) in the rear axle.
STEP 11
G0905060
Place two 10-ton hydraulic bottle jacks under the
frame in the location shown.
STEP 12
G0905055
Have an assistant balance the axle assembly using a
long pipe or bar inserted through the eye-bolt
installed in Step 10.
STEP 13
Remove the four axle mounting bolt nuts from the
bolts front and rear. Discard the Nylock
®
nuts.
STEP 14
Jack the machine equally from side to side on each
jack until the chassis is high enough to clear the rear
axle. Adjust the jack stands to support the chassis.
1
2
To Next Page
Loading...
