Gehl RS5-34 - Page 245

RS5-34 Telescopic Handler BOOM ASSEMBLY
PRINTED IN U.S.A. 701-7 913241
Alt
=
to
hide
template
information
Alt+ to display template information
Template
Name:
OML
_
2
_
col
907871E
Template Date: 1997_02_12
STEP 17
G1005029
Remove the two OEM 4129 lifting brackets from the
boom.
STEP 18
G0905011
Install the slave cylinder upper pivot pin. Complete
Steps 9, 10 and 11 of Section 606 of this manual for
correct procedures.
STEP 19
G0805231
Install the top pivot pin in both lift cylinders. Complete
Steps 9, 10 and 11 of Section 607 of this manual for
correct procedures.
STEP 20
G0805199
Install the boom rear cover (1) using the four bolts
(2).
STEP 21
G1005026
Remove the hoist and lifting chain from the front of
the boom.
STEP 22
Start the engine and check boom operation in a clear
area.
STEP 23
Shut down the engine and check for hydraulic fluid
leaks. Correct any leakage problems found and add
hydraulic fluid as needed.
2
1
View thousands of Crane Specifications on FreeCraneSpecs.com
View thousands of Crane Specifications on FreeCraneSpecs.com