What causes sluggish response to acceleration in my Gehl Compact Loader?
A sluggish response to acceleration in your Gehl Compact Loader can be caused by: * Air in the hydraulic system. Cycle the lift and tilt cylinders to maximum stroke and maintain pressure for a short time to clear air from the system. * The hydraulic oil supply being too low. Check for a low oil level in the reservoir. * Low hydrostatic system charge pressure. Add oil.
Why won't my Gehl SL3635 Compact Loader engine start, even though it turns over?
If your Gehl Compact Loader's engine turns over but won't start, consider the following: * The engine cranking speed may be too slow. Recharge or replace the battery, or pre-warm the engine in cold temperatures. * The auxiliary valve might be engaged. Return the control valves to neutral. * The fuel tank could be empty, or the fuel gauge sender might be faulty. Refill the fuel tank. * The glow plug module may be malfunctioning. Check electrical connections and voltage, replacing as needed. * The fuel shut-off solenoid may not be energizing. Check electrical connections and voltage to the shut-off solenoid. * The engine oil may not be warm enough. Install a pan heater. * The ambient temperature may be too low. Install a pan heater.
Why is the entire electrical system not functioning on my Gehl Compact Loader?
The entire electrical system might not be functioning on your Gehl Compact Loader due to several reasons: * The battery disconnect switch may be OFF. Turn it ON. * A 15 ampere breaker might be tripped. Check the circuit and locate the trouble before resetting the breaker. * The main wiring harness connectors at the rear of the ROPS may not be properly plugged in. Check these connectors. * Battery terminals or cables could be loose or corroded. Clean and retighten them. * The battery may be faulty and require testing or replacement.
What to do if the lift arm will not lower or raise on my Gehl SL3635?
If the lift arm will not lower or raise on your Gehl Compact Loader: * Raise lift arm and disengage support device. * Check electrical connections to solenoid. Repair or replace as needed. * Lower restraint bar. * Check electrical connections to the switch. Replace switch as needed.
What should I do if there's no down pressure on the bucket of my Gehl SL3635 Compact Loader?
If there's no down pressure on the bucket of your Gehl Compact Loader, take control out of float position.
What to do if auxiliary hydraulics do not function on Gehl SL3635?
If the auxiliary hydraulics on your Gehl Compact Loader do not function: * Make sure the restraint bar is lowered. * If the lock solenoid is malfunctioning, check electrical connections to the lock solenoid and repair connections as needed.
What causes no response from hydrostatic drive or lift/tilt systems on Gehl SL3635?
If there is no response from either the hydrostatic drive or the lift/tilt systems on your Gehl Compact Loader: * The hydraulic oil viscosity might be too heavy. Allow a longer warm-up or replace existing oil with the proper viscosity oil. * The hydraulic oil supply may be too low. Check for a low oil level in the reservoir. * There may be a drive coupling failure. Replace the coupling.
What causes jerky lift arm and bucket action on my Gehl SL3635 Compact Loader?
Jerky lift arm and bucket action on your Gehl Compact Loader can be caused by: * A seat or restraint bar switch malfunction. Check electrical connections to the switches and replace as needed. * Air in the hydraulic system. Cycle lift/tilt cylinders to maximum stroke and maintain pressure for a short time to clear air from the system. * Low oil in the hydraulic reservoir. Check and add oil.
Why is my Gehl SL3635 hydrostatic drive overheating?
If the hydrostatic drive on your Gehl Compact Loader is overheating: * The drive system may be overloaded continuously. Improve the efficiency of operation. * The lift/tilt or auxiliary system could be overloaded continuously. Improve the efficiency of operation. * The oil cooler fins might be plugged with debris. Clean the oil cooler fins. * The loader might be operated in a high-temperature area with no air circulation. Reduce the duty cycle and improve air circulation.
What to do if my Gehl SL3635 Compact Loader's starter will not engage?
Procedure for safely shutting down the machine before servicing or leaving it unattended.
Key safety advice for before starting, during operation, and maintenance.
Importance of guards, shields, and the operator restraint bar for safety.
Details on the operator's seat and the safety interlock system's function.
Information on ROPS/FOPS structure and the parking brake system.
Instructions for using the lift arm support device for safety during service.
Step-by-step guide for connecting an attachment to the loader hitch.
Techniques for digging effectively and safely loading the bucket.
Methods for dumping loads onto piles, into boxes, or over embankments.
General| Brand | Gehl |
|---|---|
| Model | SL3635 |
| Category | Compact Loader |
| Language | English |
To Next Page
