R-Series v5 Instruction Manual76
© 2018 Geist
GM1196 R-Series v5 Instruction Manual
Technical Support
Resetting PDU
Should the PDU lose communication, the following reset/reboot buttons are available to
help with troubleshooting:
1. Network-Reset Button ( ) : Located under the Ethernet port, users will need to use
a small pin or paper clip to contact this button. Holding the Network-Reset button for 5
seconds during normal operation will restore the default IP address and reset the
user accounts.
2. Hard-Reboot Button ( ): Pressing the Hard-Reboot button reboots the monitoring
device. This acts as a power-cycle for the device, and does not change or remove
any user information.
NOTE
This will NOT affect power to the connected devices.
Service and Maintenance
· No service or maintenance is required.
· There are no serviceable parts inside the PDU.
WARNING
Do not attempt to open the PDU or the warranty will be void.
To Next Page
Loading...