27 / 40
3030
mFlow
Configuration
level
Display Function P1 P2 P3 P4 Factory setting
4 SetCalibration Type Selecting the fitting type X X X
UnitPipe Input the unit for Di X X X
Di Input the inside diameter of the piping X X X
Size Input the fitting size X X X
Material Select the pipe material X X X
CalPointQty
Select the calibration points per measu-
ring range
XXX
Calibration Reset Reset all calibration values
SetCalDefault
Reset to factory settings XXX
ValueRange4
Input the calibration point for measuring
range 4
XXX
CalRange4 Calibrate measuring range 4
ValueRange3
Input the calibration point for measuring
range 3
XXX
CalRange3 Calibrate measuring range 3
CalZero Calibrate the zero point (0 flow)
Calculate X X X
CorrFactor X X X
15 Disposal
G All valve parts must be disposed of according to
relevant local or national disposal regulations /
environmental protection laws.
G Pay attention to adhered residual material and
gas diffusion from penetrated media.
16 Returns
G Clean the flowmeter.
G Request a return delivery note from GEMÜ.
G Returns must be made with a completed return delivery
note.
If not completed, GEMÜ cannot process
credits or
repair work
but will dispose of the goods at the operator's expense.
Note for returns:
Legal regulations for the protection of the
environment and personnel require that the
completed and signed return delivery note is included
with the dispatch documents. Returned goods can be
processed only when this note is completed.
17 Information
Note on staff training:
Please contact us at the address on the last page for
staff training information.
Should there be any doubts or misunderstandings in the
preceding text, the German version of this document is the
authoritative document!
To Next Page
Loading...
