PAG.10 PAG.11
20 seconds after the engine starting up, the alarm will immobilize the vehicle's
engine; two seconds later the siren will be activated at high volume, and the
direction indicators will start blinking repeatedly.
This signalling will continue for a minute and, after this time, the siren will be
deactivated; the turn signals will continue blinking until the anti-hijacking
function is disabled.
To deativate the function insert the electronic key in the receptacle.
In alarm condition, this implies the activation of the siren for just 2,5 seconds
rather than the standard 30 seconds.
This considerably reduces power consumption while preserving the vehicle's
battery, and it reduces the environmental acoustic pollution.
When the alarm is activated, providing an alarm condition is generated (i.e. the
vehicle is accidentally hit), the siren will be activated for about 2,5 seconds.
This condition of pre-alarm will be activated for the first 3 alarm causes.
Indeed, from the fourth cause on, the siren will be activated for about 30
seconds.
The alarm cycles will be reset every time the alarm is deactivated or when the
panic alarm is activated.
This function protects the vehicle in case the alarm would be unintentionally
deactivated.
The alarm is activated by the user, then unintentionally deactivated by the
same user (e.g. the relevant button on the remote control is pressed).
The user, unconscious about this, will leave the vehicle unprotected, although
being sure of the contrary.
35 seconds after this unintentional deactivation, the alarm will automatically
reactivate, signalling this with the standard acoustic and optical signals.
5.6 - PRE-ALARM
5.7 - ANTI-DISTRACTION
(first 3 alarm cause only)
FUNCTIONNING
FUNCTIONNING
5.3 - SHOCK SENSOR
5.5 - ANTI-HIJACKING FUNCTION
..
.
The procedure can be interrupted, by turning on the ignition switch within 35”.
If the trunk is open, the passive arming time will be interrupted, until the trunk
closing.
B.
.
.
FUNCTIONNING
FUNCTIONNING
5.4 - PASSIVE ARMING
FUNCTIONNING
!
!
!
The system may generate an alarm condition caused by a shock or a shifting of
the vehicle itself The shock sensor is buil in the alarm and is adjustable
In armed state, if the vehicle is hit or shifted, the sensor included in the alarm
system will detect this anomaly and generate an alarm.
This function allows the user to leave the vehicle sure that the alarm protection
arms itself automatically
Once the engine is switched off, the system automatically activates the
passive arming.
This will be signalled by two LED flashes and two siren high-tone beeps.
After 35 seconds the system will activate steadly, signalling the operation with
a single flash of the turn signals, two acoustic signal and the lighting up of the
LED (with a steady light).
This function ensures some sort of protection against criminals when a theft
attempt happens while the vehicle is in use.
The function indeed allows to activate the system while stopping the vehicle
with the ignition key switch on and the engine running.
With the ignition key switch on, it is possible to activate the anti-hijacking
function in the following ways:
y pressing button #1 on the remote control
By pressing button #2 on the remote control
By inserting the electronic key in the receptacle
NOTE
The activation of the anti-hijacking function will be signalled
by the system with two rapid flashes of the
turn signals and a steady LED.
Once enabled the anti-hijacking function, the remote controls won't work
anymore.
To Next Page
Loading...
