第 16 页 共 16 页
3.2 Restore default user’s own parameter
The parameter【63】of HMI can be used to set the customer’s own parameters, following methods of
operation ：
Step 1: Under operator mode, press and keys, LCD PD-0000; user require to type the
passport.
Step 2: The password is entered using （6-13）keys, then
press key. If the password is correct, enter into the technician mode, or return to
the operator mode.
Step 3: Change administrator parameters index to【62】by （4、5）keys and keys under
technician mode. The value is changed 1or 2 by (9、13)keys.
Note: If it set 1,when you want to restore the parameter,enter into index【62】and set the parameter 1;
when set 2, the parameter enter into index【62, set 2.
Step 4: Press key keep 5 second, HMI and the whole system will the current parameter set restore
the user to customize storage parameter.
When the parameter cause to the control system error, the user can restore the custom of the
parameters, the methods of operation as “4.1 Restore storage parameter for factory of control” .The
parameter【62】 is changed 1or 2, Press key keep 5 second again, the system will restore the user to
customize storage parameter.
Note：
1、 After power on, HMI only download operator mode parameter, but not technician and administrator parameter. If
all parameter is needed, technician parameter 61 can used to download all current working parameter of HMI 50.
2、 If restore other parameter of HMI storage, technician 62 can be used to make it current working parameter, and
download initiative.
3、 After single parameter modification, HMI will download the value that is different with old value of parameter.
4、 Recover default parameters, the system the best in the clear once again.
386P00480
2011-11-8
A 版
To Next Page
Loading...
